QSC SRA 3622 Bedienungsanleitung PDF herunterladen (Seite 6)

The SRA amplifier is highly durable and carefully packaged. We recommend you inspect the unit carefully

after removing it from the packaging, as occasionally there may be damage due to some unfortunate

incident during shipment. Report any damage to the shipping carrier. We recommend saving the carton and

packing material in case the unit must be shipped back to your dealer, distributor, or service center. Also

note: some freight companies consider damage claims without the original packing materials invalid.

The QSC shipping box should contain:

1- The SRA amplifier

2- This Owner’s Manual

3- Accessory packet containing:

-rack mount ears (2, used for rack mount installation only)

-four adhesive feet (for non-rack mounting installation)

-5/64” hex key (Allen wrench) for gain control security cover removal

-remote on/off (trigger) control cable, 36” long

4- IEC Power Cord

UNPACKING AND INSPECTION

SETUP- Stand-alone Mounting

If the amplifier is to be used “stand-alone” (not mounted in an equipment rack) install the self-adhesive rubber

feet on its bottom surface. The self-adhesive rubber feet are included with the amplifier.

To install the self-adhesive rubber feet:

1- Turn the amplifier upside down on

a soft, nonabrasive surface.

2- Peel the backing paper off of each

rubber foot and place near each of

the four corners of the chassis

bottom

3- Press firmly to activate the

pressure sensitive adhesive.

4- Turn the amplifier back over so

that the rubber feet rest on the

supporting surface.

1 2 3 4 5 6 7 8 9 10 11 ... 39 40

Keine Kommentare

QSC SRA 3622 Bedienungsanleitung Seite 6